Bringing this back up. Is there a way to totally remove the state of the virtual switch? I am doing speaker/amp commands and it would be nice to just have them not there.
D
Posts made by djmalcom
-
RE: ActionTiles tile with TRIGGERcmd bookmark URLposted in General Discussion
-
RE: Monoprice amp problems.posted in General Discussion
@russ So I had to put in the IP address directly...the codes wouldnt accept the localhost command. Any idea why? Thanks
-
RE: Monoprice amp problems.posted in General Discussion
@russ yes I got that far. I can run triggercmd and get the calculator and notepad to open but can’t seem to get the monoamp stuff to run. Can’t even get a simple on/off command to work.
Any additional help would be greatly appreciated.
-
Monoprice amp problems.posted in General Discussion
Evening, been following how to use triggercmd with the monoprice 6 zone amp but am running into issues where I cant even get the simplest commands such as powering on a channel to work. Any help would be greatly appreciated.
Thank you,
Jason