@Russ Hi Russ I had some issues with my raspberry Pi SD card corrupting and then trying to remember how I'd set it all up in the first place so wasn't using the app for a while.
However, I checked now and it's all working fine with no issues with the on/off status.
Thanks for your excellent work !

@Russ Hi Russ I had some issues with my raspberry Pi SD card corrupting and then trying to remember how I'd set it all up in the first place so wasn't using the app for a while.
However, I checked now and it's all working fine with no issues with the on/off status.
Thanks for your excellent work !

@Russ One other strange thing I've noticed is that at about 1215 AM the smarthings devices turn on by themselves. It doesn't actually trigger the command, but the device status changes to On in Smartthings.

@Russ Thanks Russ, this is brilliant. I've got it all up and running. There was one thing that took a long time to work out - in order to install the app in the smartthings app, you have to enable developer mode in the app. This is really hidden - you have to go into the settings and hold down the "about smartthings" button for 5 seconds, and then there is an option at the bottom of the settings screen (not inside the about smartthings page" to turn on developer mode. Only after doing that can you see your test devices.
Maybe worth to add to your otherwise extremely comprehensive setup guide.

@Russ Hi Russ. I was using this but today it seems to have stopped working. I think maybe linked to Smarthings discontinuing the Groovy support. Is there any alternative to run Triggercmd from Smarthings ?